Way back Wednesday- we are going to post the entire Mugen AT Civic Group A parts catalog. We think you'll be amazed at the depth of the parts Mugen made available. You could literally build a turn key competitive Group A Civic from this catalog.

Right-click on an image to see it larger.

The Mugen Group A Civic leads the way. The Group A series was hotly contested by Honda and Toyota with Honda typically having the upper hand...

Mugen Group A Civic engine parts. Forged Mugen pistons with special material connecting rods. There were a few iterations of the connecting rods through the years- some beautifully polished. The Mugen oil pan was a work of art! It strengthened the block and added oil capacity and helped eliminate windage resulting a a 5 hp gain all by itself. The Mugen 30/50 cams were very easy on the valvetrain and had a very sophisticated profile to work with the PGM-FI system.

Part 2 of the Mugen Group A Civic engine parts list- smaller diameter pulleys and the adjustable PGM-Fi ECU and controller. The Mugen hard rubber engine mounts were sold for both race and street cars and made a great improvement! Keeping the engine and engine oil cool was very important- anything over 225 degrees oil temp caused the engine to loose HP.....

Because FIA Group A rules state you must use the factory upper exhaust manifold, considerable time was spent developing the secondary to make the most power. Chromoly lightweight flywheel and AP racing clutch.

One of the big advantages Mugen had over the competition in Group A was a wide range of alternative gear ratios and final drives. With this gearing you could always keep the engine in it's fairly narrow power band. The Mugen Limited slip has been a mainstay of all Honda competition cars all the way back to 1973....

Moving on to the Mugen Group A Civic suspension parts. Here's where things get really interesting. Mugen Showa dampers and upper camber plates, and the really trick front reinforced knuckles designed to be used with an adjustable sleeve that gave even greater camber adjustment. All the different front torsion bar diameters made it easy to dial in the handling to suit the track.

Here we have the quick ratio Mugen steering box (RHD) and 21mm front sway bar. The Mugen rear trailing arms were made specifically to help keep the correct suspension geometry. Mugen made three rear springs rates available, However most opted for an even higher rate linear spring.



The Mugen Group A rear axle with adjustable Panhard rod. The Mugen internal sway bars really worked well and we sold quite a few to street and race enthusiasts. Check out those Mugen 15" wheels......!!!!



We have covered how Mugen made the AT Civic go and handle, so how did they make it stop? 4 piston AP calipers and full floating front brake rotors, single master cylinder and rear disc conversion with all the needed brake lines.



Here's the Mugen brake proportioning assembly and yes- the FIA required a hand brake.....



The Mugen Group A fuel system. A custom ATL 90 liter fuel cell with pump and swirl tank. Don't forget the Mugen gauge cluster with 10K tach. And Mugen SW-36 steering wheel to grab onto!



Lastly the Mugen aluminum FIA roll cage.....



Add up all those Mugen parts with a few hundred hours of labor and this will be you!